LM2902DTBR2G

Share

Or copy the link below:

Mfr.Part #
LM2902DTBR2G
Manufacturer
onsemi
Package / Case
14-TSSOP (0.173, 4.40mm Width)
Datasheet
Download
Description
IC OPAMP GP 4 CIRCUIT 14TSSOP
Stock
14,982
In Stock :
14,982

Request A Quote(RFQ)

* Fullname:
* Company:
* E-Mail:
  Phone:
  Comment:
* Quantity:
Manufacturer :
onsemi
Product Category :
Instrumentation, OP Amps, Buffer Amps
Halogen Free :
Halogen Free
Output Current :
40mA
Terminal Form :
Gull wing
ECCN Code :
EAR99
Packing Method :
Tape and Reel
Base Part Number :
LM2902
JESD-609 Code :
e4
Lifecycle Status :
ACTIVE (Last Updated: 18 hours ago)
Architecture :
VOLTAGE-FEEDBACK
Slew Rate :
0.6V/µs
Bandwidth :
1MHz
Pin Count :
14
Frequency Compensation :
yes
Factory Lead Time :
2 Weeks
Common Mode Rejection Ratio :
50 dB
Terminal Pitch :
0.65mm
Surface Mount :
yes
Nominal Supply Current :
1.2mA
Operating Temperature :
-40°C~105°C
Voltage - Supply, Single/Dual (±) :
3V~32V ±1.5V~16V
Operating Supply Voltage :
16V
Moisture Sensitivity Level (MSL) :
1 (Unlimited)
Number of Pins :
14
Power Supply Rejection Ratio (PSRR) :
50dB
Operating Supply Current :
1.4mA
Radiation Hardening :
No
Time@Peak Reflow Temperature-Max (s) :
40
Height Seated (Max) :
1.2mm
Published :
2005
Peak Reflow Temperature (Cel) :
260
Packaging :
Tape and Reel (TR)
Average Bias Current-Max (IIB) :
0.5μA
Voltage - Input Offset :
2mV
Lead Free :
Lead Free
Mounting Type :
Surface Mount
Terminal Position :
Dual
Terminal Finish :
Nickel/Palladium/Gold (Ni/Pd/Au)
REACH SVHC :
No SVHC
Output Current per Channel :
40mA
Power Supplies :
5/30V
Current - Input Bias :
90nA
Number of Terminations :
14
Supply Voltage :
5V
Amplifier Type :
GENERAL PURPOSE
RoHS Status :
ROHS3 Compliant
Voltage Gain :
100dB
Number of Functions :
4
Micropower :
yes
Low-Offset :
No
Length :
5mm
Pbfree Code :
yes
Input Offset Voltage (Vos) :
7mV
Number of Channels :
4
Bias Current-Max (IIB) @25C :
0.25μA
Package / Case :
14-TSSOP (0.173, 4.40mm Width)
Datasheets
LM2902DTBR2G
Introducing Instrumentation, OP Amps, Buffer Amps onsemi LM2902DTBR2G from Chip IC,where excellence meets affordability. This product stands out with its Base Part Number:LM2902, Bandwidth:1MHz, Operating Temperature:-40°C~105°C, Number of Pins:14, Mounting Type:Surface Mount, Number of Terminations:14, Number of Channels:4, Package / Case:14-TSSOP (0.173, 4.40mm Width), LM2902DTBR2G pinout, LM2902DTBR2G datasheet PDF, LM2902DTBR2G amp .Beyond Instrumentation, OP Amps, Buffer Amps onsemi LM2902DTBR2G ,we also offer OP07CDR, TS321CX5 RFG, NE5532ADR, Our vast inventory has you covered. Contact us now for immediate solutions.

onsemi LM2902DTBR2G


4 Channels 40mA per Channel 90nA 50 dB Instrumentational OP Amps 0.5μA 16V 3V~32V ±1.5V~16V LM2902 14 Pins 14-TSSOP (0.173, 4.40mm Width)

LM2902DTBR2G Overview


In order to protect the op amps, a 14-TSSOP (0.173, 4.40mm Width) case is used. There are two types of operational amplifiers in this circuit. In the case of Tape & Reel (TR) cases, linear amplifier will be delivered. In recent months, the number of terminations has approached 14. It consists of a total of 14 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. It has 14 pins that make up the linear amplifier. In terms of input offset voltage, operational amplifier rates 7mV. This electronic component is recommended to be mounted using the mounting type Surface Mount. It is recommended that this op amp ic be operated at a temperature no higher than -40°C~105°C for optimal performance. In order for this instrumentation amplifier to operate, the supply current needs to be between 1.4mA and 10 . Maintain 100dB as the voltage gain. Buffer op amp is equipped with 4 channels on the device. The operating supply voltage of the buffer op amp is rated at 16V. As a result of this, the buffer amplifier is packed in TAPE AND REEL.

LM2902DTBR2G Features


14 Pins
supply voltage of 5V
100dB voltage gain


LM2902DTBR2G Applications


There are a lot of ON Semiconductor
LM2902DTBR2G Instrumentational OP Amps applications.


  • Differentiator circuits
  • Logarithmic operation circuits
  • Exponential operation circuits
  • Multiplication circuits
  • Division circuits
  • Precision measurement
  • Power control
  • Information processing
  • Weak signal detection
  • Signal amplification
Purchase

You may place an order without registering to Chip IC. We strongly recommend that you log in before purchasing as you can track your order at any time.

RFQ (Request for Quotations)

It is recommended to send RFQ to get the latest prices and stock availability about the part.Our sales will reply to your inquiry within 24 hours.

Payment Method

For your convenience, we accept multiple payment methods in USD, Such as:PayPal, Credit Card, and wire transfer.

IMPORTANT NOTICE

You may place an order without registering to 1. You'll receive an order confirmations by e-mail soon . (Please remember to check the spam box if you didn't hear from us). 2. Since stock availability and prices may change at any time, the sales will reconfirm the order details and update you at soonest time.

Shipping Method

Most of our products are shipped via FEDEX,DHL,UPS and SF EXPRESS...

Shipping Cost

Shipping Cost starts at $40, but some countries will exceed $40. For example (South Africa, Brazil, India, Pakistan, Israel, etc.).If customer have shipping account, we can make shipment under customer’s shipping account with freight collect directly.

The basic freight (for package ≤0.5 KG ) depends on the time zones and countries

Delivery Time

Once the goods are shipped, estimated delivery time depends on the shipping methods you chose. You can track it by the tracking no.

Manufacturer related products

Catalog related products

  • ROHM Semiconductor
    IC CMOS 2 CIRCUIT 8SOP
  • Diodes Incorporated
    IC OPAMP GP 1 CIRCUIT SOT25
  • Texas Instruments
    IC OPAMP GP 2 CIRCUIT 8SOIC
  • Texas Instruments
    IC OPAMP GP 4 CIRCUIT 14SOIC
  • Texas Instruments
    IC OPAMP GP 2 CIRCUIT 8SOIC
RFQ
BOM