MCP6H72T-E/SN

Share

Or copy the link below:

Mfr.Part #
MCP6H72T-E/SN
Manufacturer
Microchip Technology
Package / Case
8-SOIC (0.154, 3.90mm Width)
Datasheet
Download
Description
IC OPAMP GP 2 CIRCUIT 8SOIC
Stock
44,909
In Stock :
44,909

Request A Quote(RFQ)

* Fullname:
* Company:
* E-Mail:
  Phone:
  Comment:
* Quantity:
Manufacturer :
Microchip Technology
Product Category :
Instrumentation, OP Amps, Buffer Amps
Gain Bandwidth Product :
2.7MHz
Min Operating Temperature :
-40 °C
Operating Temperature :
-40°C~125°C
Maximum Operating Supply Voltage :
±6/12 V
Frequency Compensation :
yes
Amplifier Type :
GENERAL PURPOSE
Base Product Number :
MCP6H72
Low-Offset :
No
Package / Case :
8-SOIC (0.154, 3.90mm Width)
Product :
Operational Amplifiers
Qualification Status :
Not Qualified
Power :
No
Terminal Position :
Dual
Min Dual Supply Voltage :
1.75 V
Moisture Sensitivity Level (MSL) :
1 (Unlimited)
Shutdown :
No Shutdown
Time@Peak Reflow Temperature-Max (s) :
40
Micropower :
yes
Mount :
Surface Mount
ECCN Code :
EAR99
Reach Compliance Code :
Compliant
RoHS :
Compliant
Max Dual Supply Voltage :
6 V
Current - Input Bias :
10pA
Radiation Hardening :
No
Input Offset Voltage-Max :
4000 µV
Number of Channels per Chip :
2
Terminal Pitch :
1.27 mm
Packing Method :
Tape and Reel
Supply Voltage Limit-Max :
13.2 V
Terminal Finish :
Matte Tin (Sn) - annealed
Wideband :
No
Number of Pins :
8
Number of Terminations :
8
Supply Current-Max :
1.2 mA
Voltage Gain-Min :
100000
Height Seated (Max) :
1.75mm
Packaging :
Tape and Reel (TR)
JESD-30 Code :
R-PDSO-G8
Screening Level :
Extended
Type :
General Purpose Amplifier
Unity Gain BW-Nom :
2700 kHz
Power Supplies :
+-1.75/+-6/3.5/12 V
Series :
--
Pin Count :
8
Mounting :
Surface Mount
Factory Lead Time :
8 Weeks
Mounting Type :
Surface Mount
Number of Functions :
2
Supplier Device Package :
8-SOIC
Max Operating Temperature :
125 °C
Package :
Tape and Reel (TR)
Base Part Number :
MCP6H72
Product Type :
Op Amps - Operational Amplifiers
Number of Circuits :
2
Voltage Gain :
120dB
Current - Supply :
480μA
Common Mode Rejection Ratio :
76 dB
Output Type :
Rail-to-Rail
Supplier Package :
SOIC N
Seated Height-Max :
1.75 mm
Surface Mount :
yes
Low-Bias :
yes
HTS Code :
8542.33.00.01
Architecture :
VOLTAGE-FEEDBACK
Number of Terminals :
8
Voltage - Supply, Single/Dual (±) :
3.5V~12V ±1.75V~6V
Slew Rate :
2V/μs
Max Supply Voltage :
12 V
Length :
4.9mm
Min Supply Voltage :
3.5 V
Terminal Form :
Gull wing
Package Shape :
RECTANGULAR
Voltage - Input Offset :
1mV
Power Supply Rejection Ratio (PSRR) :
82dB
RoHS Status :
ROHS3 Compliant
Supply Voltage :
5V
Product Status :
Active
Lifecycle Status :
Production (Last Updated: 2 years ago)
Width :
3.9 mm
Number of Elements :
2
Current - Output / Channel :
53 mA
JESD-609 Code :
e3
Programmable Power :
No
Manufacturer :
Microchip Technology Inc
Peak Reflow Temperature (Cel) :
260
Published :
2012
Temperature Grade :
Automotive
Datasheets
MCP6H72T-E/SN
Introducing Instrumentation, OP Amps, Buffer Amps Microchip Technology MCP6H72T-E/SN from Chip IC,where excellence meets affordability. This product stands out with its Operating Temperature:-40°C~125°C, Package / Case:8-SOIC (0.154, 3.90mm Width), Number of Pins:8, Number of Terminations:8, Type:General Purpose Amplifier, Mounting Type:Surface Mount, Base Part Number:MCP6H72, MCP6H72T-E/SN pinout, MCP6H72T-E/SN datasheet PDF, MCP6H72T-E/SN amp .Beyond Instrumentation, OP Amps, Buffer Amps Microchip Technology MCP6H72T-E/SN ,we also offer OP07CDR, TS321CX5 RFG, NE5532ADR, Our vast inventory has you covered. Contact us now for immediate solutions.

Microchip Technology MCP6H72T-E/SN


10pA 76 dB Instrumentational OP Amps 3.5V~12V ±1.75V~6V MCP6H72 8 Pins 8-SOIC (0.154, 3.90mm Width)

MCP6H72T-E/SN Overview


In the package, you will find a 8-SOIC (0.154, 3.90mm Width)-case to contain the op amp ic. The instrumentation amplifier in this picture is of the General Purpose-type. A Tape & Reel (TR) case is used for delivering the op amp. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. This linear amplifier should be powered by an 5V battery. The op amp ic has an array of 8 pins on it. For this electrical component, Surface Mount is the recommended mounting type. According to the manufacturer, this buffer op amp works well at -40°C~125°C , which is a good operating temperature. You should keep the voltage gain at 120dB for the time being. A instrumentation amplifier like this has 2 circuits. Buffer amplifier produces Rail-to-Rail signals, which is one of its many benefits. To operate this buffer amplifier, the temperature must not be lower than -40 °C. A temperature greater than 125 °C should not be used for the operation of buffer amplifier. 2 elements make up the design of this buffer amplifier. The linear amplifier is packaged by using a TAPE AND REEL axis. There is a recommendation that this electrical part be used with a supply with 480μA current rating. This electric component can work from a voltage of under 12 V as far as supply voltage is concerned. A voltage of 3.5 V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 6 V volts when you conduct this part. In this case, -- represents the instrumentation amplifiers' series number. In this op amp ic, the minimum voltage gain is 100000. 8 wire terminals are provided on this op amp.

MCP6H72T-E/SN Features


8 Pins
supply voltage of 5V
120dB voltage gain
Output Type: Rail-to-Rail
8Terminations


MCP6H72T-E/SN Applications


There are a lot of Microchip Technology
MCP6H72T-E/SN Instrumentational OP Amps applications.


  • Multiplication circuits
  • Division circuits
  • Precision measurement
  • Power control
  • Information processing
  • Weak signal detection
  • Signal amplification
  • Signal filtering
  • Signal operation
  • Video computer boards
Purchase

You may place an order without registering to Chip IC. We strongly recommend that you log in before purchasing as you can track your order at any time.

RFQ (Request for Quotations)

It is recommended to send RFQ to get the latest prices and stock availability about the part.Our sales will reply to your inquiry within 24 hours.

Payment Method

For your convenience, we accept multiple payment methods in USD, Such as:PayPal, Credit Card, and wire transfer.

IMPORTANT NOTICE

You may place an order without registering to 1. You'll receive an order confirmations by e-mail soon . (Please remember to check the spam box if you didn't hear from us). 2. Since stock availability and prices may change at any time, the sales will reconfirm the order details and update you at soonest time.

Shipping Method

Most of our products are shipped via FEDEX,DHL,UPS and SF EXPRESS...

Shipping Cost

Shipping Cost starts at $40, but some countries will exceed $40. For example (South Africa, Brazil, India, Pakistan, Israel, etc.).If customer have shipping account, we can make shipment under customer’s shipping account with freight collect directly.

The basic freight (for package ≤0.5 KG ) depends on the time zones and countries

Delivery Time

Once the goods are shipped, estimated delivery time depends on the shipping methods you chose. You can track it by the tracking no.

Manufacturer related products

Catalog related products

  • ROHM Semiconductor
    IC CMOS 2 CIRCUIT 8SOP
  • Diodes Incorporated
    IC OPAMP GP 1 CIRCUIT SOT25
  • Texas Instruments
    IC OPAMP GP 2 CIRCUIT 8SOIC
  • Texas Instruments
    IC OPAMP GP 4 CIRCUIT 14SOIC
  • Texas Instruments
    IC OPAMP GP 2 CIRCUIT 8SOIC
RFQ
BOM