MCP6141-E/MS

Share

Or copy the link below:

Mfr.Part #
MCP6141-E/MS
Manufacturer
Microchip Technology
Package / Case
8-TSSOP, 8-MSOP (0.118, 3.00mm Width)
Datasheet
Download
Description
IC OPAMP GP 1 CIRCUIT 8MSOP
Stock
14,296
In Stock :
14,296

Request A Quote(RFQ)

* Fullname:
* Company:
* E-Mail:
  Phone:
  Comment:
* Quantity:
Manufacturer :
Microchip Technology
Product Category :
Instrumentation, OP Amps, Buffer Amps
Voltage - Input Offset :
3mV
Supply Voltage :
5V
Terminal Finish :
Matte Tin (Sn)
Product Type :
Op Amps - Operational Amplifiers
Terminal Pitch :
0.65mm
Nominal Supply Current :
600nA
Time@Peak Reflow Temperature-Max (s) :
40
Operating Supply Current :
600 nA
Output Current :
21mA
Input Offset Voltage-Max :
3000 µV
Voltage - Supply, Single/Dual (±) :
1.4V~6V
Product Category :
Operational Amplifiers - Op Amps
Common Mode Rejection Ratio :
60 dB
Architecture :
VOLTAGE-FEEDBACK
Output Current per Channel :
21 mA
Number of Functions :
1
Amplifier Type :
GENERAL PURPOSE
Low-Offset :
No
Peak Reflow Temperature (Cel) :
260
Type :
General Purpose Amplifier
Shutdown :
No Shutdown
Maximum Operating Temperature :
+ 125 C
Input Offset Voltage (Vos) :
3mV
Shut Down Support :
No
Input Bias Current :
100 pA
Terminal Form :
Gull wing
Qualification :
AEC-Q100
Height :
0.85 mm
Number of Channels per Chip :
1
Low-Bias :
yes
Terminal Position :
Dual
Number of Terminals :
8
Seated Height-Max :
1.1 mm
Surface Mount :
yes
Voltage Gain dB :
115 dB
Moisture Sensitivity Level (MSL) :
1 (Unlimited)
Gain Bandwidth Product :
100kHz
Min Supply Voltage :
1.4 V
Average Bias Current-Max (IIB) :
0.005μA
Voltage Gain-Min :
56200
Operating Temperature :
-40°C~125°C
Output Type :
Rail-to-Rail
Max Supply Voltage :
5.5 V
Packaging :
Tube
Number of Pins :
8
Power Supplies :
1.5/5 V
Base Product Number :
MCP6141
Supplier Device Package :
8-MSOP
HTS Code :
8542.33.00.01
Micropower :
yes
Voltage Gain :
115dB
Screening Level :
Extended Industrial
Number of Elements :
1
RoHS Status :
Non-RoHS Compliant
JESD-609 Code :
e3
Current - Input Bias :
1pA
Supply Voltage Limit-Max :
7V
Supply Type :
Single
Factory Lead Time :
7 Weeks
Current - Output / Channel :
20mA
Power Supply Rejection Ratio (PSRR) :
70dB
Reach Compliance Code :
Compliant
Number of Terminations :
8
Product Status :
Active
Base Part Number :
MCP6141
Qualification Status :
Not Qualified
Pbfree Code :
yes
Manufacturer :
Microchip
Brand :
Microchip Technology
Width :
3 mm
Lead Free :
Lead Free
RoHS :
Compliant
Max Operating Temperature :
125 °C
Number of Circuits :
1
Frequency Compensation :
YES (AVCL>=10)
Number of Channels :
1
Package Shape :
Square
Mounting :
Surface Mount
Power Supply Type :
Single
Slew Rate :
0.003V/μs
Power :
No
Mounting Type :
Surface Mount
JESD-30 Code :
S-PDSO-G8
Packing Method :
Tube
Unity Gain BW-Nom :
100 kHz
Product :
Operational Amplifiers
Temperature Grade :
Automotive
Mounting Style :
SMD/SMT
Minimum Operating Temperature :
- 40 C
Lifecycle Status :
Production (Last Updated: 2 years ago)
Min Operating Temperature :
-40 °C
Operating Supply Voltage :
5 V
Series :
--
Package :
Tube
Programmable Power :
No
Pin Count :
8
ECCN Code :
EAR99
Maximum Operating Supply Voltage :
5.5 V
Current - Supply :
600nA
Package / Case :
8-TSSOP, 8-MSOP (0.118, 3.00mm Width)
Length :
3mm
Wideband :
No
Mount :
Surface Mount
Supplier Package :
MSOP
Supply Current-Max :
0.001 mA
Published :
2007
Radiation Hardening :
No
Datasheets
MCP6141-E/MS
Introducing Instrumentation, OP Amps, Buffer Amps Microchip Technology MCP6141-E/MS from Chip IC,where excellence meets affordability. This product stands out with its Type:General Purpose Amplifier, Operating Temperature:-40°C~125°C, Number of Pins:8, Number of Terminations:8, Base Part Number:MCP6141, Number of Channels:1, Mounting Type:Surface Mount, Package / Case:8-TSSOP, 8-MSOP (0.118, 3.00mm Width), MCP6141-E/MS pinout, MCP6141-E/MS datasheet PDF, MCP6141-E/MS amp .Beyond Instrumentation, OP Amps, Buffer Amps Microchip Technology MCP6141-E/MS ,we also offer OP07CDR, TS321CX5 RFG, NE5532ADR, Our vast inventory has you covered. Contact us now for immediate solutions.

Microchip Technology MCP6141-E/MS


1 Channels 21 mA per Channel 1pA 60 dB Instrumentational OP Amps 0.005μA 5 V 1.4V~6V MCP6141 8 Pins 8-TSSOP, 8-MSOP (0.118, 3.00mm Width)

MCP6141-E/MS Overview


A 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) case is used to package the op amp. General Purpose-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Tube case. It is estimated that there will be 8 terminations in the next few months. There are a total of 8 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 5V volts. There are 8 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 3mV. It is recommended that this electronic component be mounted using the Surface Mount mounting type. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about -40°C~125°C . An 600 nA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. On this instrumentation amplifier, there are 1 circuits that are connected together. There are 1 channels on the operational amplifiers. One of the advantages of this op amp is that it outputs Rail-to-Rail signals, which is one of its many advantages. In order for op amp to function properly, the temperature should not be lower than -40 °C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 125 °C. There are a total of 1 elements in this linear amplifier. The operating supply voltage of the buffer op amp is rated at 5 V. The instrumentation amplifier is packed in the form of TUBE. As a recommendation, this electronic component should be used with a power supply that can deliver 600nA. I would like to point out that this electrical component is capable of working from a voltage below 5.5 V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 1.4 V at all times. The -- indicates the series number of the op amp. There is a minimum voltage gain of 56200 that this buffer op amp is capable of conducting. In order to connect the buffer amplifier to the wires, it is equipped with 8 terminals.

MCP6141-E/MS Features


8 Pins
supply voltage of 5V
115dB voltage gain
Output Type: Rail-to-Rail
8Terminations


MCP6141-E/MS Applications


There are a lot of Microchip Technology
MCP6141-E/MS Instrumentational OP Amps applications.


  • Addition operation circuits
  • Subtraction operation circuits
  • single/dual op amp sum and difference circuits
  • Integrator circuits
  • Differentiator circuits
  • Logarithmic operation circuits
  • Exponential operation circuits
  • Multiplication circuits
  • Division circuits
  • Precision measurement
Purchase

You may place an order without registering to Chip IC. We strongly recommend that you log in before purchasing as you can track your order at any time.

RFQ (Request for Quotations)

It is recommended to send RFQ to get the latest prices and stock availability about the part.Our sales will reply to your inquiry within 24 hours.

Payment Method

For your convenience, we accept multiple payment methods in USD, Such as:PayPal, Credit Card, and wire transfer.

IMPORTANT NOTICE

You may place an order without registering to 1. You'll receive an order confirmations by e-mail soon . (Please remember to check the spam box if you didn't hear from us). 2. Since stock availability and prices may change at any time, the sales will reconfirm the order details and update you at soonest time.

Shipping Method

Most of our products are shipped via FEDEX,DHL,UPS and SF EXPRESS...

Shipping Cost

Shipping Cost starts at $40, but some countries will exceed $40. For example (South Africa, Brazil, India, Pakistan, Israel, etc.).If customer have shipping account, we can make shipment under customer’s shipping account with freight collect directly.

The basic freight (for package ≤0.5 KG ) depends on the time zones and countries

Delivery Time

Once the goods are shipped, estimated delivery time depends on the shipping methods you chose. You can track it by the tracking no.

Manufacturer related products

Catalog related products

  • ROHM Semiconductor
    IC CMOS 2 CIRCUIT 8SOP
  • Diodes Incorporated
    IC OPAMP GP 1 CIRCUIT SOT25
  • Texas Instruments
    IC OPAMP GP 2 CIRCUIT 8SOIC
  • Texas Instruments
    IC OPAMP GP 4 CIRCUIT 14SOIC
  • Texas Instruments
    IC OPAMP GP 2 CIRCUIT 8SOIC
RFQ
BOM