EL1516AIYZ
- Mfr.Part #
- EL1516AIYZ
- Manufacturer
- Intersil (Renesas Electronics Corporation)
- Package / Case
- 10-TFSOP, 10-MSOP (0.118, 3.00mm Width)
- Datasheet
- Download
- Description
- IC OPAMP DIFF 2 CIRCUIT 10MSOP
- Stock
- 16,012
- In Stock :
- 16,012
Request A Quote(RFQ)
- * Fullname:
- * Company:
- * E-Mail:
- Phone:
- Comment:
- * Quantity:
- Manufacturer :
- Intersil (Renesas Electronics Corporation)
- Product Category :
- Instrumentation, OP Amps, Buffer Amps
- Output Current per Channel :
- 160 mA
- Series :
- --
- Common Mode Rejection Ratio :
- 90 dB
- Supply Voltage-Max (Vsup) :
- 7V
- Terminal Pitch :
- 0.5mm
- Operating Temperature (Max) :
- 85°C
- Min Supply Voltage :
- 5 V
- JESD-30 Code :
- S-PDSO-G10
- Current - Supply :
- 5.8mA
- Terminal Form :
- Gull wing
- RoHS :
- Compliant
- Qualification Status :
- Not Qualified
- Input Bias Current :
- 6.5 µA
- Supplier Device Package :
- 10-MSOP
- Consumer IC Type :
- Video Amplifier
- Supply Voltage-Min (Vsup) :
- 2.5V
- Max Operating Temperature :
- 85 °C
- Current - Output / Channel :
- 160mA
- Number of Functions :
- 2
- Number of Circuits :
- 2
- RoHS Status :
- RoHS Compliant
- Surface Mount :
- yes
- Additional Feature :
- ALSO OPERATES WITH 5V TO 12V SINGLE SUPPLY
- Voltage - Input Offset :
- 100μV
- Reach Compliance Code :
- Compliant
- HTS Code :
- 8542.33.00.01
- Max Dual Supply Voltage :
- 6 V
- Bandwidth :
- 320000 kHz
- Packaging :
- Tube
- ECCN Code :
- EAR99
- Operating Temperature (Min) :
- -40°C
- Input Offset Voltage (Vos) :
- 100 µV
- Output Type :
- --
- Mounting Type :
- Surface Mount
- Pin Count :
- 10
- Base Part Number :
- EL1516
- Min Operating Temperature :
- -40 °C
- Amplifier Type :
- Differential
- Time@Peak Reflow Temperature-Max (s) :
- 40
- Terminal Finish :
- MATTE TIN
- -3db Bandwidth :
- 350MHz
- Current - Input Bias :
- 6.5μA
- Length :
- 3mm
- Slew Rate :
- 128 V/µs
- Peak Reflow Temperature (Cel) :
- 260
- Width :
- 3mm
- JESD-609 Code :
- e3
- Operating Temperature :
- -40°C ~ 85°C
- Number of Channels :
- 1
- Mount :
- Surface Mount
- Temperature Grade :
- Industrial
- Package / Case :
- 10-TFSOP, 10-MSOP (0.118, 3.00mm Width)
- Lead Free :
- Lead Free
- Number of Pins :
- 10
- Min Dual Supply Voltage :
- 2.5 V
- Height Seated (Max) :
- 1.1mm
- Moisture Sensitivity Level (MSL) :
- 2 (1 Year)
- Voltage - Supply, Single/Dual (±) :
- 5 V ~ 12 V, ±2.5 V ~ 6 V
- Max Supply Voltage :
- 12 V
- Operating Supply Current :
- 5.8 mA
- Number of Terminals :
- 10
- Voltage Gain :
- 80 dB
- Terminal Position :
- Dual
- Radiation Hardening :
- No
- Datasheets
- EL1516AIYZ

1 Channels 160 mA per Channel 6.5µA 90 dB Instrumentational OP Amps 5 V ~ 12 V, ±2.5 V ~ 6 V EL1516 10 Pins 10-TFSOP, 10-MSOP (0.118, 3.00mm Width)
EL1516AIYZ Overview
A 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) case is used to package the op amp. Differential-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Tube case. There are a total of 10 pins on this op amp. There are 10 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 100 µV. It is recommended that this electronic component be mounted using the Surface Mount mounting type. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about -40°C ~ 85°C . An 5.8 mA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. On this instrumentation amplifier, there are 2 circuits that are connected together. There are 1 channels on the operational amplifiers. One of the advantages of this op amp is that it outputs -- signals, which is one of its many advantages. In order for op amp to function properly, the temperature should not be lower than -40 °C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 85 °C. As a recommendation, this electronic component should be used with a power supply that can deliver 5.8mA. I would like to point out that this electrical component is capable of working from a voltage below 12 V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 5 V at all times. The dual supply voltage of 6 V should be used for the conduct of this electronic component. The -- indicates the series number of the op amp. Sorting based on consumer IC type can be done by using VIDEO AMPLIFIER. I would like to draw your attention to the following extra benefit of this buffer amplifier: ALSO OPERATES WITH 5V TO 12V SINGLE SUPPLY. In order to connect the buffer amplifier to the wires, it is equipped with 10 terminals.
EL1516AIYZ Features
10 Pins
80 dB voltage gain
Output Type: --
10Terminations
EL1516AIYZ Applications
There are a lot of Intersil Corporation
EL1516AIYZ Instrumentational OP Amps applications.
- Addition operation circuits
- Subtraction operation circuits
- single/dual op amp sum and difference circuits
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
You may place an order without registering to Chip IC. We strongly recommend that you log in before purchasing as you can track your order at any time.
RFQ (Request for Quotations)It is recommended to send RFQ to get the latest prices and stock availability about the part.Our sales will reply to your inquiry within 24 hours.
Payment MethodFor your convenience, we accept multiple payment methods in USD, Such as:PayPal, Credit Card, and wire transfer.
IMPORTANT NOTICEYou may place an order without registering to 1. You'll receive an order confirmations by e-mail soon . (Please remember to check the spam box if you didn't hear from us). 2. Since stock availability and prices may change at any time, the sales will reconfirm the order details and update you at soonest time.
Most of our products are shipped via FEDEX,DHL,UPS and SF EXPRESS...
Shipping CostShipping Cost starts at $40, but some countries will exceed $40. For example (South Africa, Brazil, India, Pakistan, Israel, etc.).If customer have shipping account, we can make shipment under customer’s shipping account with freight collect directly.
The basic freight (for package ≤0.5 KG ) depends on the time zones and countries
Once the goods are shipped, estimated delivery time depends on the shipping methods you chose. You can track it by the tracking no.
















